Sea Clear Epoxy Resin for Resinart

Usage areas

• Suitable for resinart.
• Suitable for sea wave / ocean wave.
• Not suitable for table casting

Product features

• Packaged in set as A and B components
• Used at a ratio of 1 : 1 by weight (1 Unit Resin + 1 Unit Hardener)
• Clear
• Odorless
• Solvent Free
• Shiny
• Working time is 20-25 minutes.
• Demoulding time is 12-16 hours.
• It can be cast in a maximum thickness a few mm.

Usage

Mix the two products packaged as Component A and Component B, 2A and 1B. Make the mixture using a scale and while mixing, pour the “A” component into the “B” component and mix at a slow speed until a homogeneous and smooth appearance is obtained. If you wish, you can vacuum the mixture. When the mixture is ready, pour the mixture on the area you will be applying.

Considerations

• Epoxy resin is two-component and cannot be used without mixing the components.
• Do not use outside the specified application thickness range. Low thickness may cause late drying and high thickness may cause burning / yellowing problem.
• Never heat the product during mixing and application.
• Use a hot air gun to remove surface foam, or you can quickly pass a blue burner flame from the surface.
• Use a vacuum machine to completely eliminate the possibility of air bubbles.
• When preparing the mixture of products, always use sensitive scales.
• For whatever reason, do not mix any material that does not fit the system into the product.
• Make sure that the equipment you use during the application is dry and clean.
• Take care to do the applications at room temperature (+23 ° C).
• Low temperature may cause late drying and high temperature may cause premature drying.
• Low temperature causes thickening in the consistency of the products and may cause differences in application results.
• Low temperatures may cause crystallization in resins. Before using, allow the crystallized resin to dissolve by exposing it to +60 ° C to +80 ° C temperature.
• Do not move the system until you are sure that the spilled product is completely hardened. Otherwise, it may cause undulation on the surface.
• Do not forget to use work safety equipment.
• Avoid contact with your skin.
• Epoxy resins can cause allergies. If you observe an allergic reaction on your body, consult a doctor immediately.
• Store the unused product indoors at temperatures between +15 and +35 ° C, away from direct sunlight.
• Do not keep the products with the cover open.
• Keep away from children.
• Do not leave the products obtained as a result of the mixture under direct sunlight.
• Yellowing inside the package may occur in products that are waiting unused.

All of the information is given as a suggestion to get the best result from the application. It is the user’s sole responsibility to use the product for its intended purpose.